Instruction Manual.
3
KIT CONTENTS.
SEA229 RADIAL ROCKET TD 10CC
SEA22901 Fuselage
SEA22902 Wing set
SEA22903 Tail set
SEA22904 Canopy
SEA22905 Wheel Spats
SEA22906 Cowling
SEA22907 Aluminium tube
ADDITIONAL ITEMS REQUIRED.
.46 - .55
2-stroke.
.82 - 1.0 ci
4-stroke.
10cc gasoline engine.
Computer radio with 7 servos.
Glow plug to suit engine.
Propeller to suit engine.
Protective foam rubber for radio
TOOLS & SUPPLIES NEEDED.
Thin cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder’s triangle.
Wire cutters.
Masking tape & T-pins.
Thread-lock.
Paper towels.
HINGING THE FLAP.
.
Hinge.
Note :
The control surfaces, including the ai-
lerons, elevators, and rudder, are prehinged
with hinges installed, but the hinges are not
glued in place. It is imperative that you prop-
erly adhere the hinges in place per the steps
that follow using a high-quality thin C/A glue.
1) Carefully remove the flap from one of the
wing panels. Note the position of the hinges.
2) Remove each hinge from the wing panel
and flap and place a T-pin in the center of
each hinge. Slide each hinge into the wing
panel until the T-pin is snug against the wing
panel. This will help ensure an equal amount
of hinge is on either side of the hinge line
when the flap is mounted to the aileron.
3) Slide the wing panel on the flap until there
is only a slight gap. The hinge is now cen-
tered on the wing panel and flap. Remove
the T-pins and snug the flap against the wing
panel. A gap of 1/64” or less should be main-
tained between the wing panel and flap.
Summary of Contents for Radial Rocket TD 10cc
Page 30: ...RADIAL ROCKET 10cc 30...
