Instruction Manual.
19
Pushrod wire.
COWLING.
1) With the muffler, needle valve, and
spark/glow plug removed from the en-
gine, slide the cowl in place over the
engine. Temporarily install the propel-
ler and spinner in order to find the ex-
act location of the cowl. When satisfied
with the cowl placement, secure the cowl
to the fuselage using masking tape. Then
drill cowl mounting holes through the
cowl and into the fire wall. There is no
firewall in the muffler cutout- you will
have to drill above or below the cutout to
drill into the firewall. Now, remove the
cowl.
Trim and cut.
Because of the size of the cowl, it may be nec-
essary to use a needle valve extension for the
high speed needle valve. Make this out of suf-
ficient length 1.5mm wire and install it into
the end of the needle valve. Secure the wire in
place by tightening the set screw in the side of
the needle valve.
Summary of Contents for Radial Rocket TD 10cc
Page 30: ...RADIAL ROCKET 10cc 30...
