Sfere PA19 Series, User Manual, Page: 13 / 24

11
5.3 System setting
E.g. set password to be 2, choose brightness degree to be L4, and select
flashing alarm value to be more than 120% of rated value.
Enter setting interface, press or button to select , then
press button to enter system setting menu. Now press or
button again to select specific items and press button again.
※
Set password
※
Choose brightness degree
※
Select flashing alarm value
5.4 Input setting
User can change input signal according to actual situation in field. Unit of
primary value is A/V. E.g. set input signal as 50.0A/75mV (user can not
change secondary value 50.0A/75mV). First enter setting menu, second
press
or button to select , third press button to enter input
signal setting menu. Now press or button again to select specific
items and press button again.
Change
number
Decimal point
flashes Change position of
decimal point
5.5 Relay output setting
User can change first relay from off to alarm mode, alarm activates after
5 seconds when DC current is higher than 6.000A with hysteresis value of
0.005A. First enter setting interface, second press
or button to select
, third press button to enter relay output setting menu. Now