SEW MOVIFIT SC series, Operating Instructions Manual

Page: 7 / 148

2
Safety Notes
Other applicable documentation
Operating Instructions – MOVIFIT
®
SC
7
Safety functions MOVIFIT
®
SC may not perform any safety functions unless they are described and
expressly approved.
Use only components in safety applications that were explicitly delivered in this version
by SEW-EURODRIVE.
2.4 Other applicable documentation
The following publication must also be observed:
• "DR/DV/DT/DTE/DVE AC Motors, CT/CV Asynchronous Servomotors" operating
instructions
2.5 Transportation, putting into storage
Observe the notes on transportation, storage, and proper handling. Observe the climatic
conditions as stated in the section "Technical Data".
2.6 Installation
Installation and cooling of the devices must be carried out according to the guidelines
listed in the corresponding documentation.
Protect MOVIFIT
®
SC from excessive strain.
The following applications are prohibited unless measures are expressly taken to make
them possible:
• Use in potentially explosive atmospheres
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, radiation, etc.
• Use in non-stationary applications with strong mechanical oscillation and impact
loads; see section "Technical Data".
2.7 Electrical connection
Observe applicable national accident prevention guidelines when working on live
MOVIFIT
®
SC (e.g. BGV A3).
Electrical installation must be carried out according to pertinent regulations (e.g. cable
cross-sections, fusing, protective earth connection). For any additional information, refer
to the applicable documentation.
You will find notes on EMC-compliant installation (e.g. shielding, grounding, configura-
tion of filters and routing of lines) in the MOVIFIT
®
SC documentation. The manufacturer
of the system or machine is responsible for maintaining the limits established by EMC
legislation.
Preventive measures and protection devices must comply with the regulations in force
(e.g. EN 60204 or EN 61800-5-1).