3
Electrical installation
Connecting the GBG10..A keypad
Addendum to the Operating Instructions – GBG10..A..
10
3
Electrical installation
3.1
Connecting the GBG10..A keypad
WARNING
Risk of crushing if the drive unit starts up unexpectedly when connecting the
CBG10..A keypad with switch position "CW" or "CCW".
Severe or fatal injuries.
•
Before connecting the keypad to the drive unit, set the "MODE" switch to "AUTO"
position and the rotary switch to "STOP" position.
NOTICE
Damage due to permanent connection of keypad and drive unit. The GBG10..A
keypad is not designed for permanent connection within a system.
Damage to the device.
•
Disconnect the keypad from the drive unit after use and remove it from the sys-
tem.
Plug the plug connector of the GBG10..A keypad into the following plug connector of
the drive unit:
•
X5131 (SNI or DSC designs)
•
X5132 (DAC designs)
The following figure shows an example of a connection between GBG10..A keypad
and MOVIGEAR
®
/DRC.. drive unit:
MODE
AUTO
MODE
LOCAL
SPEED
f1
SPEED
f2
BRAKE
AUTO
BRAKE
MANUAL
MOVI
GEAR(R)/DRC CONT
ROLL
BO
X
(SNI/DSC/DAC)
RESET
STOP/RESET
CW
CCW
X5131 (DSC/SNI)
X5132 (DAC)
MOVIGEAR
®
-B
DRC..A
GBG10-11A-00
20739053067
23569654/EN – 07/2017
