![background image](http://html1.mh-extra.com/html/carlon/hs4317d/hs4317d_instruction-manual_2558879001.webp)
INSTRUCTION GUIDE
Key Pad Entry Alarm
– HS4317D
ENCLOSED YOU WILL FIND:
• Key Pad Entry Alarm
• Magnet
• Double-sided tape
• Optional screws
TOOLS NEEDED:
• Small Phillips head screwdriver
BATTERIES NEEDED (not included):
• Three “AAA” alkaline batteries
INSTALLATION
For indoor use only. You must mount the alarm and magnet so the magnet rests
with its arrow pointing toward one of the alarm’s markings for proper alignment.
Choose a location that lets you install the magnet on a door or window and the
alarm next to it on the frame or vice versa. The distance between the alarm and
the magnet must be no more than 5/16 inch. Use the supplied screws or the
supplied adhesive tape and follow these steps to mount the alarm and magnet.
1. Remove the screw on the bottom of the alarm and remove the back cover.
2. Use two screws or two of the pieces of supplied adhesive tape to mount the
back cover. If using tape, make sure mounting surfaces are free of dust, oil and
other substances that could affect adhesion.
3. Install 3 “AAA” alkaline batteries onto appropriate terminals.
4. Slide the alarm onto the back cover.
5. Replace the screw on the bottom of the alarm.
6. Use the two remaining screws or the other piece of the supplied adhesive tape
to mount the magnet so the arrow points toward one of the markings on either
side of the alarm.
SETTING THE SECURITY CODE
You can set your own four-digit alarm security code.
• Your alarm’s security code is preset to 1234 at the factory. Be sure you use a
different security code.
• You must enter all four numbers within 10 seconds, or the red indicator turns off
and the alarm exits the procedure and resets to the previous security code.
• If you remove the battery, the security code resets to 1234.
Follow these steps to set your own security code.
1. Press keys 3 and 4 at the same time. The red indicator lights.
2. Enter the current security code. The yellow indicator flashes.
Note:
If this is the first time you are setting the code, enter 1234.
3. Enter the desired four-digit code. The yellow indicator will flash once and a short
beep will sound to indicate a security code change.
ARMING/DISARMING
When the unit is powered up, two beeps will sound and then the unit will be in the
off mode. The unit can be turned on by pressing the keys 1 and 2 at the same
time. A beep will sound indicating the unit is armed. The unit can be turned off by
pressing the keys 1 and 2 at the same time. Two beeps will sound indicating the
unit is disarmed. To change between chime and alarm mode, the unit has to be
turned off first and set to the desired mode. Then turn on the unit.
1. Chime Mode
Simply set the mode switch to ”chime” and turn on the unit. The electronic chimes
sound when someone opens the door. If not, readjust the position of the magnet.
2. Alarm Mode
Set the alarm’s mode switch to ”instant” or “delay” and turn on the unit. Then close
the door. A beep will sound to indicate the unit is armed.
Note:
If you don’t close the door within about 30 seconds, a continuous beeping
sound will alert you that the door is not closed. You can only turn off the beeping
sound by closing the door.