INFLATABLE BOA
TS
®
®
10
GRAB LINE INSTALLATION:
IMPORTANT: To properly install the inflatable boat’s grab line, first
inflate the product. Feed the grab line through the eyelets on each of
the rope holders. Then tie the two loose ends in a square knot at the
rear of the product.
The assembled oar is to be inserted into the oar locks from the
outside of the product. The oar retainer ring is then placed onto
the top half of the assembled oar, from the inside of the product, to
prevent the oar from sliding into the water (see below).
OAR ASSEMBLY:
(for models with oar included)
Join the two shafts together by screwing them together into the
coupler. Attach the blade to the shafts by screwing in into the bottom
of the shaft.
Replacement Part #2000004151
Square Knot
Retainer
Ring
Coupler
Shaft
Shaft
Blade
