Step 9: Insert Drawers.
WARNING:
NOTE:
Step 10:
How to pull the drawer out of the unit?
To pull the drawers out of the unit, pull the black plastic clip on the right side of the drawer up, then push on the black
plastic clip on the left side of the drawer down. Now you can pull the drawer out.
After attaching the two drawers, place the Drawer
Mats (#18) inside the drawers.
ASSEMBLY INSTRUCTIONS
(pg 5 of 7)
Pull out the Ball Bearing track towards you.
Place Drawer Mats (#18).
UltraHD Stainless Steel Pegboard Workcenter (Model No. 20267)
Once you insert the drawers, tighten the screws
for Small Drawer Middle Support (#48-1), Small
Drawer Left Support (#48-2) and Small Drawer
Right Support (#48-3).
Pull out the drawer sliders and inner ball bearing
track completely. Then attach and fit the Drawer
to the inner track of the sliders and slide drawers
in.
Pull the ball
bearing track
towards you.
PULL
UP
PULL
DOWN
#18
