order to ensure that the temperature is evenly distributed), the timer and programme functions
are automatically suspended. The programme will automatically resume only after the door is
closed again and the rotary control
key is pressed.
–
Press
twice to interrupt the programme.
–
A 5-beep signal indicates that the pre-programmed cooking time has elapsed; at the same time,
the interior lighting switches off and the display shows ‘
End
’.
–
Open the door and remove the container with the food.
–
In order to achieve an even heat distribution through the food, the container should be set aside for
several minutes.
Note: If the door is not opened immediately after the pre-programmed operating time has elapsed, a
4-beep signal is heard every 2 minutes.
Note: The following steps are used for setting the cooking time:
0 – 5 minutes : 10-second steps
5 – 10 minutes : 30-second steps
10 – 30 minutes : 1-minute steps
30 – 95 minutes : 5-minute steps
–
The cooking times generally depend on several factors.
- Microwave radiation penetrates the surface of the food. For larger pieces of food, a longer
cooking time is therefore needed than for the same amount of food if cut into pieces. The food
should also be evenly distributed on the plate.
- To ensure that any germs in the food are safely destroyed, the food needs to be exposed to high
temperatures for a sufficiently long period.
- As a basic rule: half the amount
- half the time recommended
double the amount - almost double the time recommended
.
Cooling-off function:
This microwave oven has an automatic cooling feature.
After any operating time exceeding two minutes, the cooling fan will automatically run for three
minutes after the programme stops.
Clock
:
Once the unit has been connected to the power supply, the display shows ‘
1:00
’ and an acoustic
signal is heard.
1. Press once. The hour digits are shown in the display.
2. Turn the rotary control
to set the correct hour value.
3. Press . The minute digits are shown.
4. Turn the rotary control
to set the correct minutes.
5. Press to finish setting the time. The symbol ‘
:
‘ flashes and the correct time is shown.
The time setting process can be cancelled by pressing the
key.
The clock must be set when the appliance is connected for the first time, and also if a power failure
has reset the clock.
The microwave function
:
To programme the unit for cooking, the correct mode (microwave), the required power setting and
the cooking time must be selected, before the programme sequence can be started. The power setting
is selected by repeatedly pressing
. The cooking time can be pre-set to a maximum of 95 minutes.
23
Summary of Contents for MW 9718
