SEVERIN KM-3902, Instructions For Use Manual

Page: 10 / 58


Do not let the power cord hang free.

No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with. Any
misuse can cause severe personal injury.

This appliance is intended for domestic or
similar applications, such as in
- st af f kitchens, of f ices and ot her
commercial environments,
- agricultural areas,
- h o t e l s , m o t e l s e t c . a n d s i m i l a r
establishments,
- bed-and-breakfast guest houses.

In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualified
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The address can be
found in the appendix to this manual.
Operation
Control switch
The control switch allows for the following
settings:
II The unit is switched on - high speed
I The unit is switched on - low speed
0 The unit is switched off
P The unit remains running at high operating
speed as long as the pulse switch is held at
the P -position.
General information
Before using the unit for the first time, all
attachments and accessory parts must be
cleaned as described in the section
General
Care and Cleaning .
Always fit the required attachment first before
use.
Note : This kitchen appliance is equipped with a
safety switch. The appliance can only be
switched on if the selected attachments are
correctly fitted and locked.
Turn off the unit after use and wait until the
motor has come to a complete standstill before
changing or removing any attachments.
A. Chopping/mincing
– Fit the drive shaft into the drive clutch.
– Fit the bowl to the motor housing with its
handle on the right and turn clockwise all
the way to engage the safety lock.
– Place the drive shaft extension on the drive
shaft.
– Fit the chopping/mincing blade over the
shaft extension and push it firmly down as
far as it will go so that it almost touches the
bottom of the bowl.
Caution : Hold the blade only by its fitted
plastic grips - the blades are extremely
sharp.
– Put the ingredients (max. 500g) into the
bowl.
– Place the lid on the bowl and lock it by
turning clockwise until it clicks into place
in the handle.
– For safety reasons, use the pestle at all times
when feeding the ingredients into the food
chute. During operation, the pestle should
remain inserted.
Short-term operation:
When using t he chopping/mincing
function, please note that the appliance is
designed for short-term operation only, i.e.
the unit must not be operated for more than
1 minute at a time. Switch off the appliance
after wards and allow sufficient time
(around 5 mins) for it to cool down before
resuming operation.
Operation settings
– We recommend using the Pulse setting ( P) .
The desired degree of chopping/mincing
(from coarse to fine) for meat, onions, dried
fruit, celery, fish etc. is normally achieved
after approx. 15-30 seconds already.
B. Kneading and stirring/mixing
– Fit the drive shaft into the drive clutch.
– Fit the bowl to the motor housing with its
handle on the right and turn clockwise all
the way to engage the safety lock.
– Place the drive shaft extension on the drive
shaft in such a way that the extension
almost touches the bottom of the bowl.
10