12
In case of a defective appliance
A defective appliance can cause material
damage and injury:
∙
Check the appliance for damage
before every use. Do not operate if the
appliance shows any sign of damage.
∙
In the event that you detect damage,
please contact our customer service
department by phone or email (see
appendix).
∙
Repairs to this appliance or its power
cord must only be carried out by our
customer service.
Overview and parts included
1. Pulp
container
2. Juice
container
3. Sorbet
insert
4. Sieve insert, coarse
5. Sieve
insert,
fi
ne
6. Function
switch
7. Cleaning
brush
8. Power cord with plug
9. Drive
unit
10. Worm-drive housing
11. Worm-drive
12. Lid with feeder tube
13. Pestle
Operation
Short-time operation
The appliance is designed for short-term operation only,
i.e. it should not be operated continuously for more than 15
minutes. Allow it to cool down for another 30 minutes, after
which it may be used again.
Useful tips for juice extraction
∙
Almost all common types of fruit are suitable for juice
extraction, such as apples, pears, plums, strawberries,
grapes, oranges, melons, kiwi fruit, pineapples, mangoes
and papayas.
∙
The following vegetables are also suitable for ef
fi
cient
juice extraction: carrots, kohlrabi, celery or cucumber.
However, spinach, rocket (rucola) or different types of
lettuce may be processed as well.
∙
Bananas or dried fruits are not suitable for extraction.
They contain very little juice and might cause damage.
∙
After cleaning, roughly cut up the fruit or vegetables and
remove any stones, cores or seeds to prevent damage to
the appliance.
∙
To facilitate extraction, hard fruit and vegetables such
as carrots, fennel or kohlrabi should be cut into smaller
pieces.
Thermal safety cut-out
The appliance has an integral safety cut-out which protects
it from overheating. Should the cut-out have been activated,
disconnect the appliance from the mains power and allow
it to cool down to room temperature.
Then press the reset
button on the base of the drive unit.
Before using for the
fi
rst time
Clean the appliance as described in the section
Cleaning
and care
.
Switch
∙
The appliance is equipped with a function switch.
0
switched
off
I
normal
operation
R
reverse operation
∙
Do not attempt to change from
I
directly to
R
or vice
versa. To prevent damage to the appliance, always wait
for the motor to come to a standstill
fi
rst.
Sieve- and sorbet inserts
Fine sieve insert
→
for clear juices
To extract juices with a low fruit pulp content
Coarse sieve insert
→
for thick juices and jam
To extract juices with a high fruit pulp content, for making
jam and puréed tomatoes for tomato sauces.
Note:
The
coarse sieve
insert is not suitable for
extracting juice from harder food items with a low water
content such as carrots, kohlrabi etc. Cocktail tomatoes
are also unsuitable for processing.
Sorbet insert
For preparing sorbet from frozen fruit.
Assembling the appliance
1. Select the appropriate insert.
2. Fit the insert into the recess of the worm-drive housing
so that the protruding part of the insert engages over
the rim of the worm-drive housing. Push the insert
lightly down.
3.
Ensure that the rubber tab under
the worm-drive housing
fi
ts inside
the pulp outlet:
4. Fit the worm-drive housing with the pulp outlet facing
left and the juice outlet facing forward to the drive unit.
