10
ENGLISH
In order to ensure safe charging of the batteries, the
following order has to be considered:
1.
Open the protection cap of the charging
socket
2.
Connect the charger plug of the charger with
the charging socket
3.
Connect the charger (power supply) with the
mains
4.
After successful charging, disconnect the
charger from the mains, disconnect from the
luminaire and close the charging socket with
the protection cap.
1.
Battery operation / dimming feature
By pressing the button in the lid you switch the
SETO CRAFTSMAN ST-200 RC on / off and select the
desired operating mode. The switching is noticeable
through a noticeable resistance.
The desired brightness can be set by pressing the
push button several times.
The setting is made in the following steps:
press once
= high
press twice
= low
press three times = off
In addition, the lamp can be switched off by pressing
the switch for 3 seconds when in „High“ mode.
3. Charger
The charger is equipped with an optical display
(integrated LED). The charge status is shown by a
progress bar:
4.
Battery Level
When the charge level is low, only the last bar of
the integrated status LED lights up. In this case, the
lamp should be charged as soon as possible to avoid
damage to the battery due to deep discharge.
A flashing LED signals the current charging progress
during charging.
When the battery is fully charged, all five LEDs light
up blue.
2. Charging
WARNING!
The charger is only suitable for indoor use. Char-
ging is only to be carried out in dry spaces.
INFORMATION!
The luminaire should be charged when the bright-
ness noticeably decreases or the red indicator LED
(behind the front panel at the top of the light)
starts flashing. Otherwise, the batteries may be
damaged due to deep discharge.
Operation
For cleaning the plastic / metal parts, do not use
solvents, alcohols or other chemicals. Use a soft, dry
and lint-free cloth for the cleaning.
Cleaning and care
To maintain the battery life we recommend
• to charge the battery as soon as the LED status
indicator flashes
• to not operate permanently on the charger
• to not store deeply discharged
Battery care
Protection cap for
charging socket
Charging socket
Magnet
Button switch ON/
OFF / mode change
Capacity display
The SETO CRAFTSMAN ST-200 RC has built-in ma-
gnetic holders with which the lamp can be securely
attached to a wide variety of metal surfaces. The
magnets are located on the back of the upper and
lower cover of the lamp.
Magnetic holder
