Setolite ALDEBARAN 360 GRAD FLEX 360 IP65 2.0, Instructions For Use Manual, Page: 14 / 16

14
ENGLISH
ATTENTION!
Luminaire may only be operated with the original
supply cable, supply line in replacement / repair
only from manufacturer or his service representative.
Control unit
The ALDEBARAN
®
360 GRAD FLEX-C 2.0 luminaire can
be controlled via the two switches and the rotary knob
(only with dimmable versions) on the control unit. The
control unit is integrated into the supply line.
With every switch, two light modules are switched
(ON / OFF).
By turning the potentiometer clockwise, the illuminance
level can be increased, counter clockwise lowers the
illuminance level (only with dimmable versions).
Control unit
Potentiometer
Switch ON / OFF
Preparation for operation
Connectors (only -C versions):
To connect the supply lead, insert the cable connector
of the lead into the cable socket of the luminaire
and turn it clockwise. To disconnect the lead, turn the
connector counterclockwise and pull out the cable
connector.
WARNING! Electrical current!
Make sure that the luminaire is disconnected from the
mains supply before connecting or disconnecting the
supply line.
Malfunction
Error Possible cause Solution
One light module without function Defect in light module Ask your trained electrician or the
manufacturer
Two light modules without function Switch OFF Check the control elements (switches)
All four light modules without function No voltage Check the voltage supply
Luminaire cannot be dimmed Defect of the rotary knob Ask your trained electrician or the
manufacturer
Extreme discrepancy in the brightness
of one light module
Defect of the active cooling Ask your trained electrician or the
manufacturer
Cable plug
(illuminant)
Cable connector
(supply line)