11
ENGLISH
Controls
A
C
B
D
(A) Carrying handle
(B) Cable winding
(C) Bolt receiver
(D) Locking bolt
Initial operation
The LED spotlight is only to be connected to an alternating current – with the voltage according to the rating plate –
to a properly installed safety socket. Please note that your system corresponds to the relevant VDE guidelines.
If you have any questions about this, please contact your energy supplier or your electrician. Of course we are at your
disposal if you have any questions.
ATTENTION!
In the case of versions of the LED spotlight with other plug-in systems (not Schuko®), the voltage according to the
rating plate must be observed.
WARNING!
• Lay the cables in such a way that there are no tripping hazards and they are protected from mechanical damage
such as tearing off or being run over.
• If necessary, secure the cables with tape or cable ties.
• Make sure the LED spotlight is securely set up and fastened before use.
• Also observe the applicable regulations on occupational safety!
Electric connection
Connect the mains plug of the connecting cable to your mains connection socket.
The LED spotlight is ready for operation once it has been connected to the mains power supply.
