IM-977W4 Pairing with Wireless Headset
– Headset Information
3019 Alvin DeVane Blvd.
Ste. 560
Austin, TX 78741
Phone: (650) 965-8020
CORPORATION
®
TECH SUPPORT: 650-965-8020 ext. 703
Questions or technical issues? Please call:
CSB-900W4
Wireless
Headset
Page of
5
8
The CSB-900W4 Wireless Headset is shipped already paired to the IM-977W4.
See below for pairing information if needed.
·
The IM-977W4 and a wireless headset will retain pairing identity whenever powered off
and power on again.
·
Turn on the headset by turning the Volume Control knob Clockwise. The headset will
beep 1 to 3 times indicating battery charge level:
0 beeps = fully discharged battery / charging required
1 beep = low battery / charging required
2 beeps = moderate charge remaining
3 beeps = full charge
·
When powered on, the headset will link to the IM-977W4 within about 5 seconds, then
will beep 3 more times, from a low tone to a high tone, indicating the link was
successful.
The LED’s on the headset and the IM-977W4 will both slowly flash Green
indicating linked status.
If the headset needs to be re-paired with the IM-977W4, or paired with another IM-977W4:
1) Disconnect the Portable Radio Adaptor Cable (PRAC) if one is installed (re-connect after pairing).
2) Set the IM-977W4 for Pairing Mode (press and hold Pairing Button about 3 seconds, until Status LED slowly flashes Amber).
3) Turn on the wireless headset, and after the charge indicator beeps press and hold the 2 PTT buttons on the bottom of the cups at
the same time, after a few seconds there will be a low beep, then release the buttons.
4) After a few seconds the headset will beep again 3 times, from low to high pitch, indicating that the pairing was successful. The
LED’s on the headset and the IM-977W4 should now be slowly flashing Green.
For further details and instructions, refer to the CSB-900W4 Wireless Headset User Guide, found on the Setcom website:
www.setcomcorp.com
. A video of the pairing process can be found at: www.setcomcorp.com/cr/900wireless.php.
