26
Setup with the Servonaut
ProgCARD or Radio
HS12/HS16
Your RX9 has standard settings and is
ready for action. With the Servonaut
ProgCARD or a radio HS12/HS16 you
can further adjust these settings. The
ProgCARD is available as an acessory.
Check it’s manual on how to use it.
I
mportant:
The RX9 saves settings 10
seconds after the last change. Wait till
the RX9 flashes red twice. If you discon-
nect the receiver before that you loose
your settings.
Multichannel 7
(Automatic
or
Bind)
Set to
Automatic
: If you use a Servo-
naut Radio HS12/HS16 the multichan-
nel is detected automatically.
Attention: If you use a Zwo4 plug-in the
setting to Automatic doesn’t work.
Set to
Bind
: The information that a mul-
tichannel is active is set while binding.
After changing the setting you have to
bind again.
Multichannel 8
(Automatic
or
Bind)
Same as Multichannel 7 but for channel
8.
Channel Extender
(Automatic, On
or
Off)
This setting determines if output
SERVO9 emits a signal for a Channel
Extender or a normal servo signal.
Set to
Automatic
: The RX9 detects
what is connected at SERVO 9. If con-
nected servos aren’t detected, set it to
Off manually.
Set to
On
: The RX9 emits a signal for
the channel extender R+3 or R+7. You
can’t connect a normal servo!
Set to
Off
: The RX9 emits a normal
servo signal.
Summary of Contents for RX9
Page 2: ......
Page 18: ...Notizen...