Servomech ILA 100 A, Installation, Operation And Maintenance Manual, Page: 22 / 23

Servomech S.p.A. 21.15-25-50-100-150-200.E - Rev. 01 DD (M/Y) 10/19 22
9.2 Push rod guides lubrication
THE LUBRICATION OF PUSH ROD GUIDES IS NOT REQUIRED FOR ILA 15 A, ILA 15 B ACTUATORS.

Relube the push rod guides using proper grease nipples (n°2 grease nipples, as shown on Fig. 9.3).

Grease nipple type: DIN71412 M6
Figure 9.3 – Push rod guides lubrications
DO NOT CONFUSE THE LINEAR DRIVE GREASE NIPPLE WITH THE PUSH ROD GUIDES GREASE NIPPLES
(SEE SECTION 9.1 “LINEAR DRIVE LUBRICATION”).

Apply the grease quantity indicated in Tab 9.1.

Extend and retract the push rod over its entire stroke for 3 full cycles.

If necessary, remove excess of lubricant from push rod.
9.3 Hinged head TF lubrication
THE LUBRICATION OF HINGED HEAD (TF) IS REQUIRED ONLY FOR ILA A/B 100-150-200 ACTUATORS.

Relube the hinged head using proper grease nipples, as shown on Fig. 9.4.

Grease nipple type: DIN71412 M6
Figure 9.4 – Hinged head TF lubrication

Apply the grease until the steel bush is filled.

If necessary, remove excess of lubricant from the hinge pin.
Push rod guides grease nipples (2×)
Ingrassatori della guida stelo (2×)
Hinged head TF grease nipple
Ingrassatori della guida stelo (2×)