8
USER MANUAL
NOTE:
A fully filled water tank can work continuously for 3-6 hours. The working time depends on different
parameters, food type, frequency of door openings, as well as other factors. When the display flashes “LO H2O”,
fill the water tank immediately. Failure to refill the water tank may result in damaged unit and/or voided product
warranty.
NOTE:
Different kinds of food will affect the cabinet temperature and humidity. The temperature on display is the
cabinet temperature, not the food temperature. Follow all HAACP and safe food handling guidelines as dictated by
Local, State and Federal governments.
4. Set the humidity parameters as required (See humidity settings instruction).
5. Set the temperature parameters as required (see temperature settings instruction).
6. Allow the unit 30 minutes to preheat to the desired temperature and humidity levels.
Operating Instructions:
1. To lock the controller, press and hold “-“ on the control panel until the display shows “OFF”.
2. To unlock the controller, press and hold “-“ on the control panel until the display shows “ON”.
NOTE:
while unit is locked, the display will readout cabinet temperature. Temperature and humidity are unable to
be adjusted while the control is locked.
NOTE:
The unit’s controlled will default to the last temperature and humidity setting upon start-up.
Temperature Instructions:
NOTE:
Refer to the recommended settings chart for ideal settings for a variety of foods.
1. Press the “
” button to start (the display will show “tSP”).
2. Press the “
” button again (the display to show the current cabinet temperature).
3. Press “
” or “
” buttons to modify temperature between 86-194°F.
4. After 15 seconds, the temperature setting will be stored, and the display will return back to normal mode.
Humidity Instructions:
NOTE:
Refer to the recommended settings chart for ideal settings for a variety of foods.
NOTE:
Before setting the humidity, fill the water reservoir tank with 1 gallon of distilled water.
1. Press the “
” button to start (the display will show “hSP”).
2. Press the “
” button again (the display to show the current cabinet humidity).
3. Press “
” or “
” buttons to modify humidity between 1-5.
4. After 15 seconds, the humidity setting will be stored, and the display will return back to normal mode.
