SerVision MVG200, Configuration And Management Manual, Page: 41 / 241

SerVision Embedded Video Gateway System Guide
Configuring System Settings 40
Figure 35: Static IP settings
Fill in the fields as follows:
 Field  Description
IP Address Specify the static IP address of the unit on the cabled LAN. The address should conform to
the standards of the LAN.
Subnet Mask Modify the LAN subnet mask as necessary. The subnet mask should be the one the LAN
uses.
Default
Gateway
Fill in the IP address of the gateway through which the LAN connects to the internet.
If you do not know the IP address of the gateway, consult the network administrator or
your ISP.
Note: If this field is not filled in correctly, external network services will not be available
through this network. These include accessing the unit remotely (even through proxy and
DDNS services), SMS, e-mail notifications, and other services.
DNS Fill in the IP address of the DNS server. A DNS server enables you to enter names instead
of IP addresses for the proxy and DDNS servers. The DNS server may be operated by your
internet provider (home installation) or on your network (some office installations).
If you do not know the IP address of the DNS server, consult the network administrator or
the ISP.
Note: If this field is not filled in correctly, you will not be able to specify IP addresses as
host names. For example, the address of the SMTP e-mail server will have to be defined as
IP numbers. In addition, DDNS will not perform updates if there is no valid DNS address.
5. Click Update and then save the settings. They will be implemented after the unit is restarted (see Saving
Configuration Changes , page 156).
Modem
The
Modem
screen is used to configure the way the unit connects to a cellular network. Modem support in models
that use SerVision routers (MVG400, MVG200, and UVG) is slightly different from modem support in the
CVG-M, which has a built-in modem GSM and therefore does not need a router.
NOTE:
If you use a cellular modem to make the Video Gateway accessible remotely, you may have to use a
SerVision proxy server to facilitate client connections to the unit. For additional information, see
Proxy
and DDNS Settings , page 57.