SerVision MVG200, Configuration And Management Manual, Page: 157 / 241

SerVision Embedded Video Gateway System Guide
Saving Configuration Changes 156
Saving Configuration Changes
As you make changes in each screen, you click the Update button to save the changes. However, in order to
complete the save operation and update the Video Gateway, you need to carry out the steps described below. Most
configuration changes only take effect after you carry out all of these steps.
NOTE:
Changes in the
WiFi
and
Network Priorities
, changes in the
Modem
screen of the MVG and
UVG400, and modifications to camera brightness, contrast, and saturation settings are implemented
immediately when you click the
Update button. To save them permanently, the changes must be saved,
but restarting the unit is not necessary. All other configuration changes are implemented only after they
are saved and the system is restarted.



To save all changes:
1. Do one of the following:



In the orange Update Confirmation (ATTENTION) message below the
Main Menu , click “Click here to
go to Save Settings page.”



In the
Main Menu
, under System , click Save Settings .
The
Save Settings
screen opens:
Figure 182: Save Settings screen
2. In the
Save Settings
screen, click Save Changes to System . The unit stores the changes permanently, and
the
System Restart Page
screen opens: