Servend MD 150, Installation & Service Manual

Page: 38 / 64

38
USER MAINTENANCE
DAILY CLEANING
All cleaning must meet your local health department regulations. The following cleaning instructions are
provided as a guide.
Clean the exterior and drain pan:
1. Turn off the key switch located on either right or left
side of the unit.
2. Lift the grid and remove it from the drain pan.
3. Using mild soap, warm water and a clean cloth, wipe
the drain pan and splash panel. Then, rinse with clean,
warm water. Allow plenty of warm (not hot) water to
run down the drain of the drain pan, to remove syrup
residue that can clog the drain opening.
4. Wash the grid, then rinse with clean water. Place
the grid back in the drain pan.
5. Wash all exterior surfaces of the unit with warm
water and a clean cloth. Wipe again with a clean,
dry cloth.
Clean the dispensing valves:
6. Remove nozzles and diffusers from beverage
valves.
7. Rinse nozzle and diffuser with warm, clean water.
8. Clean nozzles and diffusers with soapy water and
a soft bristle brush.
9. Clean the underside of the beverage valves with
warm, soapy water. Rinse with clean damp towel.
10. Replace nozzles and diffusers on valves.
11. Turn on the key switch.
CAUTION: Use only warm soapy water to clean the exterior of the tower. Do not use solvents or
other cleaning agents . Do not pour hot coffee into the drain pan. Pouring hot coffee down the
drain pan can eventually crack the drain pan, especially if the drain pan is cold or still contains ice.