SPLICE™ MKII MANUAL V.1.1
7
www.serpentaudio.com
Link In:
The SPLICE-500™ MKII can be stereo linked with a second unit for stereo
applications using the supplied cable. To connect two SPLICE-500™ MKII units
together, connect the supplied cable from J202 on unit “A” to J202 on unit “B”. The
link wire can be secured in the wire hook on the PCB. Refer to the diagram below
for the location of J202. Stereo mode is enabled by placing the “Link” toggle switch
on both units to the up position.
600R Loading Jumper:
The SPLICE-500™ MKII allows for easily terminating the output signal with a 600R
load for optimal signal transfer for use with both vintage and modern gear.
Note: When connecting the SPLICE-500™ MKII’s output to vintage/600R
equipment (typically known as “bridging”), the loading jumper should be
disabled (connected to pins 2 & 3). When connecting the output to modern
equipment (or when the Mix function is enabled), the Loading jumper
should be enabled (connected to Pins 1 & 2). The SPLICE-500™ MKII is
factory set with the jumper enabled. See diagram below.
