RELEASE
Revision B1
©Serious Integrated, Inc.
45
SHIP PROGRAMMING CONNECTOR 200 (SPC200)
Into the SHIP Programming Port is plugged a small connector – the SHIP Programming
Connector 200, or SPC200.
This small connector is polarized – plugging it backwards into the SHIP Programming
Port does not connect the pins to the SIM.
The SPC delivers the SHIP Programming Port signals to a small cable-friendly connector
on one side. It leverages off-the-shelf HDMI cable/connector technology for this
purpose, though the signals and power transmitted through the cable
are
not
compatible with the HDMI standard.
Do not plug this cable into a normal HDMI port, for example on a laptop, DVD player, or TV.
The connector was chosen to leverage off-the-shelf cabling, but is not wired to the HDMI standard.
Connecting the SPC200/SPA200 with to any other device may damage the device or your SIM/SPA permanently.
Use a high quality HDMI version 1.4 cable less than 1.5 feet long, with a “Type D Micro” connector to plug into the
SPC200. The other end of the cable should be the larger, more common “Type A” cable which plugs into the SHIP
Programming Adapter 200 (SPA200).
SHIP PROGRAMMING ADAPTER 200 (SPA200)
The
Serious Programming Adapter SPA200
is an inexpensive programming/USB intelligent adapter for use with the
SIM115 and other Serious Integrated Modules. The SPA200 includes the following connectors:
USB Micro B connector exposing (via an on-SPA hub) the
USB device port of the SIM
USB Micro B connector for powering the SPA and SIM from a USB AC power adapter
HDMI Type A connector for connection to the
SPC200
At its very simplest, the SPA200 enables connectivity between a PC USB port and the SIM’s USB device circuitry, even if
the SIMs USB Micro B connector is not populated or is obstructed. This is necessary for development and volume
reprogramming/updating of the GUI and firmware from the SHIP environment.
The SPA200 has numerous other features beyond the scope of this document; contact Serious for more information or
visit
www.seriousintegrated.com/SPA200
.
TAG-CONNECT E10 PROGRAMMING PORT
Tag-Connect
is a rapid-connection system designed for in-situ reprogramming or connectivity.
It
adds no cost to the target hardware and is implemented on the PCB through a simple set of
landing pads and guide holes. The SIM535 has a 14 pin pad-set designed to accommodate the
TC2070-IDC-NL
and associated
TC-FRICTION
retaining clip. The port is designed such that the
IDC
(header) connector on the TC2070 ribbon cable can plug directly into a Renesas E10
programmer/debugger without any additional adapters or cables.
Plugging into incompatible devices may damage the SIM or connected device.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
