3
SERIAL CABLES NVMe JBOF User’s Manual
2.2 Enclosure Setup
1. Remove the PCI-ENC8G-024U enclosure from its packaging, and place the enclosure next to
PC, server, or workstation.
2. Hold one of the drive trays from the enclosure and push its button downward for the release of
the lever until the lever pops out.
3. Place a drive tray on a flat and level surface, and then attach the drive into the tray.
WARNING:
You must verify the heads of the four screws are level with the drive tray while the drive is attached
to the tray; otherwise, a screw may take hold of the tray from the bottom side and prevent you to
pull the tray out of the enclosure.
4. Use four of the screws provided, and fasten the drive on the tray. Tighten each screw to fasten
the HDD snugly to the drive tray. Do not overly tighten the screws.
WARNING:
Do not force the levers to close while you insert drive modules into the PCI-ENC8G-024U enclosure.
If a lever does not close smoothly, draw out and insert the drive module again, and then press the
lever to close.
