9
OPERATION METHOD
Cooling Mode
•
When the A/C enters cooling mode automatically or cooling mode is
selected after power ON, the cooling indicator lamp lights up.
•
Press Up/Down key to adjust setting temperature (16°C~30°C)(60°F~86°F).
•
Press Speed key to choose High/Mid/Low speed.
Fan Mode
•
When pressing mode key or choosing Fan mode by pressing the remote
controller, the wind indicator lamp lights up.
•
Press Speed key to choose High/Mid/Low speed.
•
Temperature can’t be set.
Dehumidification Mode
•
When pressing mode key or choosing
dehumidification mode by pressing the
remote controller, the dehumidification
indicator lamp lights up.
•
Remove the dehumidification water wedge,
insert water manifold, place the other end
of the water manifold into the water vessel
or drainage passage, as shown in the right
figure.
•
After entering the dehumidification mode,
if room tempearture≥17°C (62°F), the compressor is ON. Then control as
follows: when room temperature ≤15°C (59°F), the compressor is OFF;
when temperature increases to room temperature≥17°C (62°F), the
compressor will start again (in order to protect the compressor, it will be
restarted 3min. later).
•
In dehumidification mode, the fan is defaulted to run at low speed, and
wind speed can’t be adjusted.
•
Temperature can’t be set.
Note
: When use dehumidify function, should remove
exit pipe components, otherwise, it will cause worse dehumidify
performance, and appear “FL” water full alarm
www.SereneLifeHome.com