Operation and Status
Wireless Security Screen
This screen is accessed by clicking the
Wireless Security
button on the
AP/Router Setup
screen.
The default security setting is
Disabled
. No configuration is required. Data is not encrypted
before transmission.
WEP Wireless Security
The following image shows the Wireless Security screen when WEP is selected.
Figure 10 Wireless Security (AP Mode - WEP)
Data - WEP Wireless Security
Security System
Select the desired option:
•
Disabled
•
WEP
•
WPA-PSK
The screen will change according to the current selection. The settings
below are only visible if WEP is selected.
Key Size
Select the desired option. Wireless Stations must use the same setting.
•
64 Bit (10 Hex chars)
- data is encrypted, using the default key,
before being transmitted. You must enter at least the default key.
For 64 Bit Encryption, the key size is Hex 10 chars.
•
128 Bit (26 Hex chars)
- data is encrypted, using the default key,
before being transmitted. You must enter at least the default key.
For 128 Bit Encryption, the key size is 26 Hex chars.
Note: Hex chars are 0~9 and A~F.
Authentication
Type
Normally, this should be left at the default value of "Automatic". If
changed to "Open System" or "Shared Key", ensure that your Wireless
Stations use the same setting.
Default Key
Select the key you wish to be the default. Transmitted data is
ALWAYS encrypted using the Default Key; the other Keys are for
25
