5
Step 4
:
Power on Genesis CPE
1.
Connect the Ethernet cable from the Genesis CPE to the
OUT
port on the PoE injector
unit.
2.
Connect the power cable to the PoE injector.
3.
Connect the PoE injector power plug to a power source.
4.
The power/status LED on the Genesis CPE should turn green when it is powered on suc-
cessfully.
Step 5
:
Signal Check and Angle Adjustment
1.
Connect one end of an Ethernet cable to the
IN
port of the PoE injector and the other end
to a computer.
2.
Access Genesis FWA CPE Web UI on the computer via the following:
URL:
Username/Password: admin/admin
3.
The device/CPE is in NAT mode by default and could be accessed at above URL directly.
If the device/CPE is configured in bridge mode and access to the local web UI is needed,
you must configure a static IP on your PC to the following - 10.10.2.10/255/255.255.0
4.
Configure the APN via the web page.
5.
Make sure the Genesis CPE eNode and cell information is correct in the
Status
and
Cell
Status
page.