Sercel GRC DATA PRO, Operation Manual, Page: 39 / 93

Data Pro P/N 10029355 Rev AE
Operation Manual Page 39 of 92
replacement of the gauge serial number with its newly entered alias name ( Figure 36 ). The exported
data log files will contain both the gauge alias name and the gauge serial number.
Figure 36
– Gauge Alias Configuration
8.6 Interface Setup for SPS
The Data Pro can interface with an ESP (Electrical Submersible Pump) gauge interface controller
called SPS-1500, which serves as the gauge interface to the downhole gauges. The SPS-1500
processes gauge 16 analyzing steps on initial power up to optimize communication settings. The SPS
then begins normal communication with the downhole ESP gauge.
NOTE:
The Data Pro displays the gauge tab after 3 minutes of power-up because of SPS-1500
initialization and synchronization processes.
Information displayed on the SPS Status tab (Figure 37):
1. Operational status of SPS
2. Restart Gauge Interface (see Section 7.4.1)
3. Firmware version
4. Operational time since the last power up
5. Line and COM voltage setting
6. Signal level during communication
7. Clear SPS Configuration (see Section 7.4.2)
8. Communication packet count
9. Total gauge channels count
10. Update firmware