Sercel GRC DATA PRO, Operation Manual, Page: 40 / 93

Data Pro P/N 10029355 Rev AE
Operation Manual Page 40 of 92
Figure 37 - Interface Setup for SPS
8.6.1
Restart Interface
Restart the gauge interface module via:
Menu

Interface Setup

Interface For Gauges

Restart Interface
During the restart of the SPS, the user can observe the following messages on the SPS LCD:

SPS Baud Rate

SPS Slave ID

SPS Firmware version

Sync Phases 1
– 16

Power Off in between to synchronize

Analyze Phases

Checking Tool

Programming Tool

Tool Response

Tool Configured!

Rcv Hdr 0

Rcv Hdr 1 (only available on U-Command ESP gauges)
8.6.2
Upload Firmware
This function allows the user to update the firmware of the internal SPS-1500 by loading a file
from the Data Pro front panel USB drive. Copy the firmware *.bin file to the root of a USB drive.
9
8
7
6
5
4
3
2
1
10