background image

 

 

5

INSTALLATION OF THE TOOTH RACK

 

 

 

ATTENTION!

 

Regulate the operator horizontal positioning so that the pinion matches the tooth rack for the 
entire width of the tooth. 

 

 

 
 

 

 

• Place the tooth rack so that, moving manually the leaf all 

along the rail, the distance between the pinion and the 
tooth rack is constantly at ~2mm. A fine vertical adjustment 
can be performed acting on the 4 grub screws (remember 
to keep the motor base horizontal with respect to the 
ground). 

 

INSTALLATION EXAMPLE OF TOOTH RACK M/16 - UP TO 400Kg

 

 

Tooth rack in nylon PA66 charged with fiberglass. Fiberglass is used as reinforcement and increases the rack robustness. 

 

•  Juxtapose the tooth rack bars, each 340mm long, so that the complete "gate + op sliding plates" width is covered. 

Fix the bars using self-tapping M6 screws, not supplied. 

•  Upon completion of the installation, vertically adjust the rack position through its slots, so that, moving manually the leaf all

along the rail, the distance between the pinion and the tooth rack is constantly at ~2mm. 

 

 

 

 

INSTALLATION EXAMPLE OF STEEL TOOTH RACK M/14

 

 

 

• Juxtapose the tooth rack bars, each 1m long, so that the complete "gate + op sliding plates" width is covered, 

eventually cutting the last bar to the right size. 

•  Weld the spacers supplied with the tooth rail to the leaf, and then apply the rail so that the spacers pass through the slots 

on the rail itself. 

•  Fix the tooth rack to the spacers using the supplied bolts. 
•  Upon completion of the installation, vertically adjust the rack position through its slots, so that, moving manually the leaf all 

along the rail, the distance between the pinion and the tooth rack is constantly at ~2mm. 

 

 

 

Summary of Contents for MT/604









Reviews: