Sequoia SAS16, Operating Instructions Manual

Page: 28 / 44

28
PREPARING FOR OPERATION AND GETTING STARTED
Preparing for operation and getting started
Assembly operation
Connect the metal rod to the handle. Attach the straps to the tank.
Adjust the straps so that the tool base plate fits snugly and comfortably
on your back.
Do not use the sprayer if it is not fully assembled or is damaged. Inspect
the sprayer to make sure it is in one piece. Do not use substances that
do not dissolve in water because they can clog the filter. The maximum
temperature of the spray liquid is +43 °C. Do not use the sprayer if the
ambient temperature is above +45 °C or below 0 °C. Do not use the
sprayer if there is no liquid in the tank.
• Charge the battery completely before use. To charge the battery,
connect the output connector of the mains adapter to the charger
connector in the sprayer housing. Then insert the plug of the
adapter cable into a 220VAC/50Hz electrical outlet.
• Pour the liquid into the sprayer through the top filling filter.
• Turn on power.
• Press the handle to start spraying.
• Release the handle to stop spraying.
• Change the spray nozzles to select the desired spray type.
Criteria for extreme limit states of battery sprayers:
• in case of deformation or disturbance of water supply integrity, it is
necessary to replace it;
• if any plastic parts are found to be broken, replace them;
• if leaks of working solution are detected from the tank, it is
necessary to replace the tank.
Cleaning and maintenance
After using the sprayer, completely remove the solution from the tank
and rinse the tank, hose, pump, rod and nozzles with clean water. This
will eliminate the possibility of a chemical reaction occurring when
other chemicals are used in the future. If chemical residues are not
removed, they can lead to corrosion and other damages to parts of the
sprayer. This is especially true for nozzles, filters and seals.