SEPTENTRIO PolaRx5TR, Reference Manual

Page: 35 / 512

1 How To...
1.16 Log SBF Files
Enabling SBF logging on one of the log sessions involves the following steps:
1. Define the SBF naming convention and file duration in the log session of interest. By
default, the receiver logs SBF blocks into a file named "
log.sbf
". You can specify any
other file name, or you can select the IGS/RINEX naming convention, where the file
name automatically changes every fifteen minutes, hour, six hours or day. File naming
conventions can be selected independently for each log session. For instance, to let
the receiver create daily files in the second log session (
LOG2
), use:
setFileNaming,LOG1,IGS24H <CR>
If the file name you selected already exists, the receiver will append new data at the
end of the existing file.
2. Use the command
setSBFOutput
to define which SBF blocks need to be logged and
at which interval (see also section 1.3). For instance, to log all SBF blocks necessary to
build RINEX files in the
LOG2
session, with a data interval of 10 seconds, use:
setSBFOutput,Stream1,LOG1,rinex,sec10 <CR>
3. Make sure that the log session is defined and enabled:
setLogSession,LOG1,enabled <CR>
4. To stop SBF logging, disable the SBF stream as follows:
setSBFOutput,Stream1,none <CR>
or temporarily disable the log session:
setLogSession,LOG1,disabled <CR>
Note that the maximum file size supported by the receiver is 4GBytes.
Section 1.15 explains how to set up log sessions, section 1.25 shows how to automatically
FTP push SBF files to a remote server and section 1.23 shows how to download log files.
35