2.
Camera Cabling
Before users connect cables, make sure that all cables and the power adaptor are placed in dry
and well-waterproofed environments, e.g. waterproof boxes. The purpose is to prevent moisture
accumulation inside the camera and moisture penetration into cables, which might lead to
camera breakdown. Please refer to the following sections for camera connection.
2.1
Power Connection
For power connection, please refer to section
C
ONNECTORS
. Alternatively, users can power the
camera by PoE if a Power Sourcing Equipment (PSE) switch is available. Please refer to the
section below for Ethernet cable connection.
2.2
Ethernet Cable Connection
For best transmission quality, cable length shall not exceed 100 meters. Connect one end of the
Ethernet cable to the RJ-45 connector of the camera / function cable, and plug the other end of
the cable to the network switch or PC.
NOTE:
In some cases, Ethernet crossover cable might be needed when connecting the
IP camera directly to the PC.
Check the status of the link indicator and the activity indicator LEDs. If the LEDs are unlit,
please check the LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
2.3
Alarm I/O Connection
C
onnect alarm devices to the first 4 pins of the camera’s 8-pin terminal block. Refer to section
C
ONNECTORS
for the pin definitions.
Summary of Contents for IS-DM200
Page 1: ... Sentry360 2015 IS DM200 User s Manual Ver 1 0 ...
Page 5: ...1 3 Dimensions The dimensions of the camera are shown below ...
Page 7: ......
Page 13: ......