3
PACKAGE CONTENTS
One (1) Single Zone Wireless Receiver
One (1) Connector
One (1) Jumper
One (1) 9V DC Battery
One (1) User Manual
For any returns, please include all components listed above with original packaging in
Resalable
Condition
.
Absolutely No Returns
will be accepted if any component is missing/damaged.
Dimensions
PROGRAMMING AND OPERATION
Power on the receiver, “dididi” will be heard indicating that the device is self-checking and that
the device is OK. For new receiver start on STEP TWO. For a used devices start on STEP ONE, if
you want to clear the memory, If not, start from STEP TWO.
STEP ONE:
Refer to item 4 of the following to delete all the learned devices.
STEP TWO:
To learn a new device into memory—Press the "SET" key and hold it on, 3 seconds
later, a beep tone is heard, release the "SET" key, the receiver will enter learning mode. Let the
SWPB series
wireless photobeam sensor send a RF signal ------ press tamper key of the
Photobeam sensor ( with “R” mark) and hold it on, then turn on the power switch to make a test
RF sending, the Photobeam will beep "di,di--" to show the new sensor has been learned into its
memory successfully. Repeat above operation to make another RF sending for learning next
sensor. After all devices have been learned, press and release the "SET” key to quit learning
mode, ‘di,di’ will be heard.
Beep (di,di--) for successfully learning a new device;
Beep (didididi,didididi,didididi) for memory is full;
Up to 4 Photobeam sensors can be learned into a wireless receiver.
