Sentiotec 1-041-405, Instructions For Installation And Use Manual, Page: 29 / 34

EN
Instructions for use for the user p. 29/34
7.3. Changing the sauna stones
Sauna stones are subject to stress by the water poured on them, and by large
ÀXFWXDWLRQVLQWHPSHUDWXUHZKLFKRFFXUGXULQJXVH7KHVDXQDVWRQHVFDQEH -
come weak and brittle.
Check the sauna stones at regular intervals and replace the stones at least
once a year.
WARNING!
5LVNRI¿UHGXHWRRYHUKHDWLQJ
If the sauna heater is used without sauna stones, the cabin walls will
EHFRPHH[WUHPHO\KRW7KLVFRXOGFDXVH¿UHV
Ɣ NEVER operate the sauna heater without the sauna stones.
1. Remove the old sauna stones.
2. Clear the stone container of limescale deposits, dust and other contamination.
3. Wash the stones thoroughly using water and a brush before use. Do not
use any cleaning additives.
4. %HIRUH¿OOLQJWKHKHDWHUZLWKWKHVDXQDVWRQHVFKHFNWKHPIRUIRUHLJQREMHFWV
and remove any remaining packaging.
5. Place the stones in the stone container. Place sauna stones loosely so that
DLUFDQÀRZWKURXJKWKHJDSV
6. Make sure that the sauna stones do not protrude beyond the edge of the
stone container.
7.4. Cleaning the evaporator tank
Drain and clean the evaporator tank after each use. Perform the following steps:
1. Wait until the water in the evaporator has cooled.
2. Place a receptacle under the ball valve at the bottom of the evaporator.
3.
7XUQWKHEDOOYDOYHWRWKHOHIWXQWLOWKHUHPDLQLQJZDWHUÀRZVRXW
4. When the evaporator tank is empty, close the ball valve.