6
Specifications
Doc 01-G0181
Rev A
Specifications
Mechanical
GENERAL SPECIFICATIONS
Overall Size
Weight
19”L x 23”W x 31”H
190 Pounds
Table 1
GENERAL CONSTRUCTION
Electroplated, welded steel frame with
a dual gearbox reduction of 600:1 and
an ultimate strength of 2,000 foot
pound. The cover is UV durable
plastic.
GATE CAPACITY
This operator is designed for maximum
size gates. In general, the operator may
work with any gate below 1000 pounds
and 22 feet, with low wind resistance,
sturdy construction, and good hinges.
Electrical
Always use a qualified electrician and follow your local construction codes when
connecting power. General guidelines are:
Line voltage required is 115 VAC
(10% [103-127]) single phase.
Wire size, accessory power (18-gauge
recommended).
Line amperage Required 15 Amps
Max.
Device controls - any insulated wire can
be used (18-24 gauge recommended).
Wire size, operator power – see
Wire Sizes and Distances
on
page 24.
NOTE:
The operator is permanently
wired; it does not use a grounding plug.
ELECTRICAL BOX
See Figure 1. Stamped aluminum housing for the processor, motor VFD drive, and
front panel PCB's. For factory repair, the complete panel can be quickly removed
and replaced.
CAUTION
Do not repair or open box!
There is a potential shock
hazard from the
High Voltage
capacitor! Danger exists even
when power is disconnected!
