Sentera STR-3, Manual

Page: 6 / 8

www.sentera.eu
MIW-STR-3-EN-000 - 24 / 10 / 2018 6 - 8
back to the table of contents
5. Because the controller enclosure is made of metal, it must be earthed and bonded
to other existing metal surfaces.
Fig. 1 Mounting dimensions Fig. 2 Mounting position
A
C
B
E
D
Article code
A
[mm]
B
[mm]
C
[mm]
D
[mm]
E
[mm]
STR-3-35L10 300 325 185 255 255
STR-3-50L10 300 325 185 255 255
STR-3-75L10 300 425 185 255 255
STR-3100L10 300 425 185 255 355
STR-3130L10 300 423 235 255 355
Correct Incorrect
50 mm 50 mm
75 mm
50 mm
1 3
2 4
6. Insert the cables through the cable glands and do the wiring according to the
wiring diagram (see
Fig. 3 ) while adhering to the information from section
“Wiring and connections” above.
6.1 Connect the power supply lines (terminals R, S, T and PE);
6.2
Connect the motor(s) (terminals U, V, W and PE) ;
6.3 If applicable, connect the unregulated output (L1 and N). It can be used
to supply a 230 VAC valve, lamp, etc. when the knob is not at ‘0’ position
(see
Table 1 below).
ATTENTION
A safety isolator/disconnect switch should be installed on the mains electricity
side of all motor drives.
The earth wire (green-yellow) of the electrical supply and of any equipment
connected to the controller must be connected to the terminals marked as PE.
Fig. 3 Wiring and connections
STR-3-35L10, STR-3-50L10, STR-3-75L10
R S T N L1 U V W
3 x 230 VAC 230 VAC
*
STR-3100L10, STR-3130L10
Pe R S T Pe N L1 Pe U V W
3 x 230 VAC 230 VAC
*
* Do not connect N from the power supply network .
ATTENTION
STANDARD 3-PHASE 230 VAC
TRANSFORMER CONTROLLER
STR-3