www.sentera.eu
UserGuide - 07 / 09 / 2021
2 - 4
HOW TO CONNECT THE INTERNET
GATEWAY TO THE WI-FI NETWORK
ARTICLE CODES
This document explains how a Sentera internet gateway can be connected to a local -
Wi-Fi network. This document applies to following article codes:
■
DIGWM
■
SIGWM
■
DIG-M-2*
■
SIG-M-2*
*
The DIG-M-2 and SIG-M-2 Internet Gateways can also be hard wired to your router. In that case, use a regular network
cable en skip the Wi-Fi setup below. Go direct to SenteraWeb setup at the end of this document.
CONNECT THE INTERNET GATEWAY TO THE WI-FI NETWORK
■
Connect the power supply
■
By default, the red LED of the internet gateway lights up. This indicates that
there is no connection with the Wi-Fi network
■
To adjust the settings of the internet gateway, proceed as follows:
►
Using your computer or mobile device, scan for available Wi-Fi networks (see
Fig. 1)
►
Connect to the Sentera Internet Gateway (XIGxM-xxxxxxxxxx) using the
password “123456789”
Fig. 1
