sensotran, s.l.
GAS SENSORS AND TRANSDUCERS
ALARM PANEL
GASVISOR
Rev. GV v1.1
User Manual
Page 6 of 11
6
3. General operation
When the GasVisor alarm panel is started up, the system takes approximately one
minute to load all the parameters. It goes into operation once this time has passed.
The panel is not configured by default, i.e. the channels are disabled and the alarm
values are not set.
The panel has several display modes. It can be modified by touching on any channel
to access the information screen and then tapping on the display mode as follows:
Selecting 1-8 shows channels 1 to 8, selecting 9-16 shows channels 9 to 16, selecting
17-24 shows channels 17 to 24, selecting 25-32 shows channels 25 to 32 and
selecting all shows all the channels.
Note: Selecting all the channels only shows the status of the detector as Ok, Alarm 1,
Alarm 2, Alarm 3 or Fault.
Once the panel has been configured in normal status, the alarms are operative and
the display shows the instantaneous sensor readings, the channel number, and the
measurement units.
The information shown on the display is divided into three screens:
1. Channel readings display.
2. Password entry for access to the configuration menu.
3. Configuration menu.
The statuses of the various configured sensors appear next to the channel number
and can be:
