1/5
RS-15
USER’S GUIDE
Universal presence and motion sensor for internal doors
The RS-15 is a sensor developed to equip automatic inner doors in high-speed trains. The RS-15 has two functions: it detects motion to give an
opening signal and presence to prevent the door from closing on a stationary person within the presence detection zone. It has been designed to be
flush mounted.
Technology
: Focused active infrared
with microprocessor
Optical features
: 15 independent IR-spots
producing a square-
shaped detection field
Mounting height (max) :
2.5 m
Tilt angles
: 0° to 20° (step=5°)
Detection area (mounting height=2m; angle=20°)
:
1 m (W) x 1.2 m (D)
Spot dimension (typical) :
130 mm (diameter)
Detection mode
: Motion and presence
Reaction time
: < 100ms
Supply voltage
: 12V to 30V AC ±10%
12V to 45V DC ±10%
Mains frequency
: 50 to 60 Hz
Power consumption
: < 3W (VA)
Output relay (free of potential change-over contact)
•
Max. contact voltage
: 42V AC - 60V DC
•
Max. contact current
: 1A (resistive)
•
Max. switching power
: 30W (DC) / 60VA (AC)
Hold time
: 0.5s to 10s
(adjustable)
LED :
Red and green LED
Connections :
Integrated 7-pin connector,
unpluggable
Mounting :
Designed to be flush-mounted
Norms and conformity
: EMC 2004/108/EEC
DIN 5510, EN 50155
Temperature range
: -25°C to +55°C
Degree of protection
: IP41
Dimensions :
140mm(L) x 38mm(W) x
55mm(D)
Weight :
0.1 kg
Material :
ABS
Color of housing
: Black smoked
Length of cable
: 1 m (total)
compliant with DIN5510
Manual adjustments
•
Sensitivity (by push buttons)
•
Shape of detection field (by push buttons)
•
Tilt angle (mechanically)
Remote control adjustments
•
Sensitivity
•
Hold time
•
Shape of detection field
•
Max. presence time
•
Security
:
:
:
:
:
4 levels
From 0.5s to 10s in 10 steps
Choice of 9 pre-programmed
fields
20s to 25min in 10 steps
4-digit entry code
Front face
Bracket
Tilt angle
adjustment
Cable
IR-Receiver
Pin
LED
Push button A
Push button B
IR-Emitter
Wiring
GREY Relay
(NC)
YELLOW Relay
(NO)
WHITE Relay
(COM)
GREEN Power
Supply
BROWN Power
Supply
After power on, the sensor launches
a setup for a few seconds. It is
advisable to stay out of the field to
finish the setup successfully.
1
Loosen lightly the screws M3 x 8 on both sides in order to slide
the brackets smoothly.
Loosen by 2-3 turns the screws M3 x 8 to orient the brackets
at 90° or 180°.
2
Fasten the screws M3 x 8 when the brackets are in the right position.
Recommended torque: 0.8 Nm; max. torque: 0.9 Nm
3
Fasten the brackets to their support by the special pan head screws
Ø
3.5 x 9.5.
TECHNICAL
SPECIFICATIONS
DESCRIPTION
AND
WIRING
USING THE
BRACKETS
