Sensidyne Gilian AIRCON-2, Operation & Service Manual, Page: 27 / 38

27
Gilian ®
AIRCON-2 HIGH VOLUME AIR SAMPLER
Sensidyne Document No. F-PRO-3100 (Rev D)
Table 3.4
Entering program mode
Note (Step 4):
If you already have a program stored in “1”, press PROG again to select Program No. 2. There are
a total of 3 possible programs that can be stored in memory at one time. If you select a program
number that is already running, a PROGRAMMING ERROR message is displayed for 5 seconds.
You must select another program number.
Step Switch/Button Action Display Example
FAULT
PROGRAMMING
HOLD SINGLE MODE
RUN TIME
PROGRAMMING
1
2
3
4
5
ON/OFF
FLOW ADJ.
KNOB
ACCEPT
PROG
ACCEPT
Switch to ON"position
Set the air flow rate by turning
counter-clockwise to increase, or
clockwise to decrease. Flow rate
is shown on the flowmeter.
Press to turn motor OFF. Puts the
unit in HOLD mode
Press to put unit in Program
Mode. Additional presses select
program number 1, 2, or 3. You
must select a program number at
this time before continuing.
Press to lock in program number
and advance to DELAY TIME
set-up.