Document
IMA0121
Rev
3
Page
4 (4)
Configuration jumper for OUT2 output
The output OUT2 can be used as a voltage or current output. The output is
configured by the jumper on top of the PCB. The configuration of the output can be
changed by moving the jumper to the desired position. The output has to be
reconfigured before the unit is powered up.
Figure 5. The upper part of the
eSENSE II
PCB seen from the back with the jumper in
voltage (default) and current position
Self-diagnostics
The system contains complete self-diagnostic procedures that are executed
automatically when the sensor is in operation. Sensors with display show a
wrench
if
an error is found. The wrench is shown during the first seconds after power up and if
the measuring range 2000 ppm is exceeded. The output OUT2 indicates the same
information by setting the output to 1 V or 2 mA.
PLEASE NOTE!
The sensor accuracy is defined at continuous operation (at least 3 weeks after
installation)
This product is in accordance with the EMC 2004/108/EC, 92/31/EEG including
amendments by the CE-marking Directive 93/68/EEC.
The product fulfils the following demands: EN 61000-4-2 level 2, EN 61000-4-3 level
2, EN 61000-4-4 level 4, EN 61000-4-6, EN 61000-4-8 level 4, EN 55022 class B
SenseAir
®
AB
(headquarter)
Stationsgatan 12
Box 96
820 60 Delsbo
SWEDEN
Phone: +46-(0)653-71 77 70
E-mail:
