Support: 866.838.5052
PG 7 |
The most important step is pairing the wireless receiver and transmitter’s frequency. The wireless
receiver, body-pack transmitter, and hand-held wireless transmitter’s setup menus function identically.
Each device has a SET, UP, and DOWN button to make adjustments to the frequency, group, sensitivity,
or pickup gain.
Frequency Pairing
Match the frequency on both the transmitter and the reciever for wireless communication.
• Push the SET button once to select between frequency / group / sensitivity / RF outputs.
• Push the UP or DOWN button to adjust the setting of a menu.
• Press and hold SET for 3 seconds to activate that frequency.
• Once you see “MHz” blinking, you are ready to select your desired frequency by using the UP and
DOWN buttons.
• Push SET again to save the setting.
Group Adjusting
Multiple microphones can transmit on the same frequency using matching groups.
• Press SET for 3 seconds, the group (G) will flash on the LCD display.
• Push UP or DOWN to select a desired group.
• Push SET again and the Channel (CH) will flash.
• Push UP or DOWN to select the desired channel.
• Push SET again to save the setting.
Sensitivity Adjusting
Optimize sound pick up by adjusting the sensitivity.
Caution: Increasing sensitivity can cause system
feedback.
• Press the SET button twice to select the sensitivity by holding it down for 3 seconds, releasing, and
pressing again for 1 second. The display will show “
Sensit
”.
• Use the UP and DOWN buttons to make the necessary adjustments.
• Push SET again to save the setting.
RF Outputs
To adjust the transmission gain, select between low or high. For extended battery life, select “rF Lo”.
• Push the SET button several times until the “rF Lo” or “rF Hi” flashes.
• Push UP to choose “Hi” for high transmitting power (50mW) and push DOWN to choose “Lo” for
transmitting power (10mW).
• Push SET again to save the setting.
6. WIreless Transmitter and Receiver Adjustments
SE-300-WR-1CHD
SE-300-WT-BODY
SE-300-WT-HAND
