There are 2 pairs of binding posts on the rear of FS-C600 so you can have several connected options.
SENSASOUND C600 Classic
Bi-Wiring
Bi-wiring can improve the low-level details and overall
transparency.
1. Remove the terminal links from the speakers.
2. Connect one set of speaker wires to the upper terminals
on speaker and one set to the lower terminals on speaker.
Connect them independently to the amplifier output.
Bi-Amping
Bi-amping allows you to use two amplifiers for greater
dynamics.
1. Remove the terminal links from the speakers.
2. Connect the upper set terminals on speaker to one
amplifier output and follow the same principle to do the
lower set terminals on speaker. We recommend you to use
identical amplifiers and identical gains.
Single–Wiring
Single wiring is the most conventional connection.
1. Keep the terminal links in place, you can also use bare
wire to link the terminal.
2. Just connect one pair of terminals to the amplifier. Always
make sure the connection consistency of terminal polarity.
System Set Up
1. Enter into the receiver’s setup menu and go to “speaker setup”. Select “small” for surround and
center speakers, and select “large” for floor standing speakers.
2. Choose the proper crossover point according to your speaker specification.
3. In the speaker distance menu, you should measure the distance between your speakers and your
mainly listening position, then input the distance into the menu.
4. When you set up the volume level menu, you should adjust the volume level carefully until each
speaker is at the same loudness and at a comfortable listening volume. A SPL meter can help you do
the setup more accurate.
4
