Sensaphone IMS-4000, User Manual, Page: 110 / 174

IMS-4000 Manual
108
Connect Input Power
Attach a power cable to a power input on the front of the PowerGate2 and plug the other end into
a 120VAC 15A outlet or into an outlet on your PDU. One right-angle power cable is included.
(Additional cables are available by ordering part # IMS-4413.) Continue adding as many power
cables as your application requires.
Figure 6: PowerGate2 Power Inputs 1-3 plugged in
Plugging In Equipment
Attach the power cord from each device to be switched into one of the outlets on the back of the
PowerGate2. Be sure to support heavy cables with tie wraps or some other method to prevent the
unit from bending down (See the figure below). Too much weight in the rear may cause permanent
damage to the enclosure.
Figure 7: Cable Support
Each outlet will pass the connected power through from the corresponding power input. Note that
the PowerGate2 is designed for 120VAC circuits only. Each outlet is limited to 15 Amps max via
breakers mounted on the front panel.