![background image](http://html.mh-extra.com/html/sennheiser/skp-2000/skp-2000_instruction-manual_1242294030.webp)
29
If a problem occurs ...
If a problem occurs ...
Problem
Possible cause
Possible solution
Plug-on transmitter
cannot be operated,
“
Locked
” appears on
the display panel
Lock mode is
activated
Deactivate the lock mode
(see page 11).
No operation
indication
Batteries are flat or
accupack is flat
Replace the batteries or
recharge the accupack
(see page 9).
No RF signal at the
receiver
Plug-on
transmitter and
receiver are not on
the same channel
Set the plug-on
transmitter to the same
channel as the receiver.
Synchronize the plug-on
transmitter with the
receiver (see page 26).
Transmission range
is exceeded
Reduce the distance
between plug-on
transmitter and receiving
antennas.
RF signal is
deactivated
(“
RF Mute
“)
Activate the RF signal
(see page 12).
RF signal available,
no audio signal,
“
MUTE
” appears on
the display panel
Plug-on
transmitter is
muted (
MUTE
)
Cancel the muting
(see page 12).
Receiver’s squelch
threshold is
adjusted too high
Reduce the squelch
threshold setting on the
receiver.
Plug-on
transmitter doesn’t
transmit a pilot
tone
Activate the pilot tone
transmission on the
transmitter
(see page 25).
Audio signal has a
high level of
background noise or
is distorted
Plug-on
transmitter’s
sensitivity is
adjusted too low/
too high
Adjust the input sensitivity
(see page 19).