![background image](http://html.mh-extra.com/html/sennheiser/hmec-460/hmec-460_instructions-for-use-manual_1240069014.webp)
12
To connect the headset via an adapter cable:
왘
Connect the XLR-3 plug
of the headset to the XLR-3 socket of the adapter cable.
왘
Connect the plug or right-angled jack plug of the adapter cable to the cigarette lighter
socket.
Powering the NoiseGard electronics via two (rechargeable) batteries
왘
Open the cover of the battery compartment
on the operating control.
왘
Insert two 1.5 V AA alkaline-manganese batteries (IEC LR 6) or two 1.2 V AA NiMH
rechargeable batteries. Observe correct polarity.
왘
Close the cover of the battery compartment
.
With NoiseGard switched on (see “Switching NoiseGard on/off” on page 21), the LED
provides information on the remaining battery/rechargeable battery capacity.
If the battery voltage is too low, NoiseGard automatically switches off to protect the
batteries from total discharge and leakage.
왘
Replace the batteries or recharge the rechargeable batteries.
LED
lights up yellow:
The battery capacity is sufficient.
LED
lights up red:
The batteries are flat. Replace the batteries.
Summary of Contents for HMEC 460
Page 1: ...Instructions for use HMEC 460 ...
Page 2: ......