EN
Using the Flex 5000
16 |
Flex 5000
Switching the wireless headphone system off
왘
Place the receiver into the transmitter’s charging compart-
ment.
The receiver switches off. The
Receiver status
LED goes off.
The charging process starts (see page 11).
Or, if you want to switch the receiver off without placing it
into the transmitter’s charging compartment:
왘
Press the
Speech intelligibility
button for 2 seconds.
The receiver switches off. The
Receiver status
LED goes off.
The transmitter automatically switches off (standby)
when there is no receiver connected. The
Transmitter sta-
tus
LED goes off.
* LED goes off
To disconnect the transmitter from the power supply system
(e.g. when you are on holiday):
왘
Unplug the power supply unit from the wall socket.
Attaching the receiver to clothing
Depending on the connected headphones or induction loop,
please observe the following attachment recommendations
for your receiver:
• Place the receiver next to you so that you can take it in
your hand and operate it.
• Use the clip to attach the receiver to your clothing. Make
sure that the headphone cable does not hinder your move-
Always store the receiver in the transmitter’s charging
compartment to ensure that it is fully charged when
needed.
If the receiver is outside the transmission range for
more than 5 minutes or if the transmitter receives no
audio signal for more than 30 minutes, the wireless
headphone system switches off automatically
(standby).
+
OFF
2s
Flex_5000_570735_0117_PRT.book Seite 16 Montag, 10. Oktober 2016 3:58 15
