Sennheiser EW 500, Instruction Manual

Page: 62 / 284

62
Inserting and changing the battery
씰 Slide the cover of the battery compartment in the direction of the
embossed arrow until it clicks audibly.
씰 Open the cover.
씰 Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
씰 Close the battery compartment.
씰 To remove the battery, push the small red lever in the battery
compartment towards the bottom side of the transmitter.
Note:
We recommend powering the transmitter by a standard PP3 alkaline
battery. If powered by a rechargeable 9 V battery, the operating time
will be drastically reduced.
Connecting the antenna
씰
Screw the antenna onto the antenna socket (M3 connection).
Connecting the microphone/line cable
Electret powering (“plug-in” power) is available at the AF input for powering
the microphone.
씰
Connect the 3.5 mm jack plug from the microphone/line cable to
the AF input (MIC/LINE) .
씰
Lock the jack plug by screwing down the locking ring .
Switching the transmitter on/off
씰
Slide back the cover plate .
씰
Press the ON/OFF button to switch the transmitter on. The red
LED lights up.
씰
To switch the transmitter off, press the ON/OFF button until “ OFF ”
appears on the display. You can then release the button. The red LED
goes off.
Muting the transmitter
Use the MUTE switch to noiselessly mute the transmitter’s audio signal
(this switch does not switch off the transmitter).