Sennheiser evolution wireless G3 EK 100, Instruction Manual, Page: 15 / 28

14
Adjusting settings via the operating menu
Adjusting settings via the operating
menu
The main menu “ Menu ”
Synchronizing a transmitter with the diversity receiver – “Sync”
You can synchronize a suitable transmitter of the ew 100 G3 series with
the diversity receiver. During synchronization, the following parameters
are transferred to the transmitter:
• Current receiving frequency (“ Frequency Preset ”, see page 15)
• Current name set for the receiver (“ Name ”, see page 16)
• Current pilot tone setting of the receiver (“ Pilot Tone ”, see page 18)
To transfer these parameters:
왘
Switch the transmitter and the diversity receiver on.
왘
On the receiver, call up the “ Sync ” menu item.
“ Sync ” appears on the display panel of the receiver.
왘
Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface of the
receiver
쐈
.
The parameters are transferred to the transmitter. When the transfer
is completed, “
” appears on the display panel of the diversity
receiver. The receiver then switches back to the current standard
display.
To cancel the transfer:
왘
Press the ON/OFF button
쐉
on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if:
– no transmitter was found or the transmitter is not compatible,
– no transmitter was found and the synchronization process was
canceled after 30 seconds,
– you canceled the transfer.
Adjusting the squelch threshold – “Squelch”
Adjustment range: “ Low ”, “ Middle ”, “ High ”, can be switched off
The squelch eliminates annoying noise when the transmitter is switched
off or when there is no longer sufficient transmitter power received by the
receiver.
왘
Adjust the squelch threshold – with the transmitter switched off – to
the lowest possible setting that suppresses hissing noise.
쐈
Menu
Low
Squelch
Call up “Squelch” Select the
desired setting
Store the setting
“Stored”
SET
SET
Squelch Squelch
Low High